Hi, I'm Steve Smith with Camper Van Freedom. These are my Mayhew six-two-two-one-five center punches. I mainly used them on twenty-twenty aluminum extrusion, and also before drilling other metal on the roof and inside the van. A quick starting dimple helped my drill bits begin exactly where I wanted the hole. This inexpensive set earned my recommendation.

The matching product picture shows four separate pointed punches. They are marking tools, used before the drill starts cutting. The point creates a small starting location; the drill bit makes the finished hole. Those are two different stages, so the punch point size is not the final hole diameter.

Without a starting dimple, my drill bit could wander as it began cutting. That could leave the hole away from the position I wanted. The diagram separates the marked location, the punch mark and the drill starting in that mark. It explains what I wanted the punch to do, before any bolt went into the assembly.

My roof-mount photographs show the profiles, connector pieces and joint hardware from the build. I cut the added light-bar beam and made three short connector pieces. Drilling those connectors came before joining the different extrusion and rack hardware. The photographs show the assembled connections and the position of their fasteners.

Laying out the work and starting the hole are separate from the later bolt-fitting job. The illustrative workshop footage shows measuring and holding a workpiece. My assembly then involved getting the slot nuts into position while starting the bolts. A good hole location helped set up that later stage; the punch was the marking tool in that sequence.

I also preferred these Mayhew punches to the punch included in my ZORUNNA kit. The Mayhew tools felt more solid and stable when I struck them against metal. The kit punch moved around more. The matching kit picture keeps that comparison tied to the product I actually used, rather than treating every punch as identical.

My page has two researched alternatives. The Mayhew twenty-four-thousand-three is a single hammer-struck center punch, rather than an assortment. The Starrett eighteen A uses a spring mechanism and an adjustable stroke to make the mark without a separate hammer. Their pictures show the different arrangements. My firsthand recommendation here is for the Mayhew set.

Thanks for watching. I'm Steve Smith with Camper Van Freedom. We covered my Mayhew center punches, starting dimples and the layout work behind my drilled roof connections. The full review, build pictures, related ZORUNNA review and current Amazon buying options are linked below. Until next time.