Hi, I'm Steve Smith with Camper Van Freedom. After mounting the roof lights and cameras, I needed a route for their cables into the van. I built that route around the rack with junction boxes, P V C pipe, cable glands and a larger entry box. Four recorded sessions covered thirty-six hours of box preparation, conduit fitting, wire work and finishing. I had already worked on the rack, light plates and camera mounts. The cable route connected those equipment positions to the inside of the van. I designed the P V C arrangement in SketchUp, then worked through it as individual boxes and pipe sections. That made the front boxes, middle boxes and larger roof-entry box separate fabrication tasks instead of one finished-roof picture. At the driver-front box, I drilled openings for the light-wire entries, installed a cable gland and ran the wires through it. I also prepared the middle driver-side box with mounting bars, P V C connectors and glands. My MAKERELE gland kit appears in the materials for this work. Each gland formed a transition between an equipment lead and a box, while the pipe connections continued the route along the rack. The passenger-front section brought more of those parts together. I drilled its box, fitted threaded P V C connectors and a wire gland, and cut the pipe leading toward the larger box. The photograph of the loose components records that fitting stage before the section was complete. Metal ties attached the conduit to the extrusion, and I returned to tighten more ties as the route came together. The larger Otdorpatio project box was the meeting point for the roof-to-interior route. I made openings through the box and roof, then applied primer and white paint around the cut area. Later photographs show the wires passing through the larger box and down into the cargo area. The outside and inside views explain the same transition from two different positions. Wire identification had its own place in the sequence. I used a label maker to label a lead running into the van. I also brought the camera's Ethernet cable through a gland into a P V C tee, and routed the driver-side wires across to the larger box. During the final session, a fish-tape wire puller helped run wires through the pipe system. My photograph shows the actual reel used at that stage. The finishing work included plastic trim around the opening into the van, another gland for the passenger-side camera, the remaining P V C connections and the junction-box covers. I cemented the remaining pipe joints and tightened the metal ties. My final diary status marked this conduit-and-wire-routing project finished. The wide roof picture belongs to that closing stage, after the earlier open-box and wire-pulling photographs. Thanks for watching. I'm Steve Smith with Camper Van Freedom. This roof-cable project connected mounted devices, individual boxes, conduit, identification and the entry into the van. The complete guide, original project photographs, diary entries and materials references are linked below. Until next time.