Hi, I'm Steve Smith with Camper Van Freedom. My passenger-side roof camera needed a custom mounting frame. I made it from aluminum extrusion and drilled connecting brackets, with the camera above a small light. Two recorded work sessions covered fourteen hours, including tool setup and parts for additional mounts. Both entries ended with the roof project still in progress. The first session started with angle-aluminum stock. I made small connecting brackets, drilled their holes and joined the extrusion pieces. The loose bracket photograph shows the two faces of the angle before assembly. The close-up shows a connecting piece inside an extrusion corner. Looking at those views together makes the relationship between the stock, the holes and the finished joint easier to follow. The small hardware took time. My diary specifically records positioning the T-nuts and getting the screws started in them. A rectangular frame may look simple in a wide photograph, but each corner still depends on engaging those individual fastening pieces. The hardware photograph belongs beside the joint picture, because it records the small parts involved in that fitting stage. Bolt length was another problem I recorded. I planned to buy shorter quarter-twenty bolts so I would not have to grind every bolt down to fit. That was a purchasing plan at the end of the first session. Keeping a proposed change separate from the pieces already fitted helps explain why the assembly was not finished when that photograph was taken. The next session began with unboxing and assembling my drill press. I then drilled larger holes in the exterior extrusion corner brackets. That setup work belongs within the fourteen-hour record, rather than treating all the time as camera attachment alone. The rest of the session included more measuring, cutting and drilling for the remaining mounts, along with cutting their extrusion. The existing camera mount also received more attachment work. I added corner brackets and made a separate bracket for the camera's front mounting hole. The camera base and the custom extrusion frame were different parts of the job. My fitting photographs show the earlier assembly, while the following day's written steps record those later bracket additions. The cable was still visible around the camera during fitting. More conduit and wire routing were planned next. For a fitting record, I would keep one row per joint, with the stock shape, hole position, hardware, actual bolt length, photograph and next change together. That separates a loose bracket, an assembled corner and a camera attachment instead of treating the whole roof as one completed item. Thanks for watching. I'm Steve Smith with Camper Van Freedom. My camera-bracket project was a sequence of small connections: angle stock, drilled holes, T-nuts, bolt lengths and another attachment at the camera base. The full guide, original photographs, diary entries and blank fitting record are linked below. Until next time.