Hi, I'm Steve Smith with Camper Van Freedom. This is the storage-bin drawer I developed during my roof-storage project. I started with a SketchUp layout, laid out timber on the patio to represent the roof dimensions, and worked through the drawer and cabinet frame with the bins in place. The useful lesson was to keep the bin, the drawer and the cabinet as three separate parts of the plan. The bin is the container I need to reach. The drawer carries the containers. The cabinet surrounds the drawer and provides room for it to move. Their dimensions are related, but they are not interchangeable. A container's lid and handles can take up more space than its base. The drawer's frame, base and lining then take up space of their own. My patio mockup gave the layout a physical reference. After designing the storage system in SketchUp, I cut timber to simulate the roof dimensions. I could arrange the frame and containers within that space and see how the pieces related to one another. The photographs show the construction and fit stage I reached, rather than a finished installation on the van. My diary records the drawer's total dimensions as twenty-nine and three-quarter inches wide, nineteen and three-sixteenths inches deep, and three and seven-eighths inches high. The separate cabinet frame was thirty-four inches wide, twenty inches deep and thirty-six inches high, intended for two rows of drawers. Those are the recorded overall dimensions. Clear inside space needs its own measurements. I cut the drawer timber, drilled the pieces and screwed them into a rectangular frame. Galvanized right-angle brackets went inside the corners. I then marked the base panel for the screws, drilled it and fastened it to the frame. Keeping the stages separate made the connections visible before the lining covered the inside. For the lining, I cut the rubber mat with scissors. I cleaned the wood, applied spray adhesive in sections and pressed the material into place with a roller. The base and sides used separate pieces. Screws and flat washers also held the mat to the timber and base. My aim was to put rubber between the containers and drawer to reduce noise and vibration. The finished inside space changes when that lining goes in. The next stage connected the drawer and taller cabinet frame with drawer slides. The extended-drawer photograph shows the bins brought out from the frame. Fit means more than placing a bin in a tray. I also need room to reach the handles, remove a lid and lift the container. The space above the bin matters alongside the drawer's forward travel. The HOMZ bins appear in my materials list for this project. The guide also shows Rubbermaid and Sterilite container alternatives for comparison; those are not additional bins I am claiming to have used. Whatever container is being planned around, its actual footprint, lid, handles and removal movement belong in the same fit record. This diary entry records twelve hours of work and ends with a plan to continue the roof-storage project. The mockup, frame and lined drawer preserve that stage of the build. Thanks for watching. I'm Steve Smith with Camper Van Freedom. My full guide includes the original photographs, recorded dimensions and a downloadable bin, drawer and cabinet fit worksheet. They are linked below. Until next time.