Hey, I'm Steve Smith with Camper Van Freedom. My upper-cabinet notes include a picture of aluminum extrusion with a rounded outside corner. The useful distinction is in the shape: a rounded cross-section is different from a frame member bent along its length. I use that distinction to organize the cabinet-edge drawing before turning an appearance idea into a cut list. A rounded outside corner changes the face of a straight member. A curved cabinet run changes the path of the whole assembly. Put those two views beside each other: an end view for the profile, and a plan view for the cabinet run. Keep the supplier's actual dimensions with the selected part instead of deriving a size from a photograph. Start the edge drawing with the frame and panel together. Show whether the panel sits in a slot, against the frame or on a separate retainer. Add its finish and the intended exposed edge. Turn the drawing around to see the hidden side too. The aisle-facing surface is only one part of the finished detail. Then draw the connection to the next member. Mark the bracket or other proposed connector, and show where its fasteners would be reached. Keep those parts tied to the exact profile drawing. An outside width alone does not describe the slot or the hardware interface. Record an unresolved connection as an open choice while the assembly is being developed. Add the door and its intended movement to the same detail. Show the space taken by the panel, hinge arrangement and neighboring cabinet. Include the exposed ends of the frame and their intended treatment. Move through the planned positions rather than checking only the closed outline. That makes the cabinet depth and the nearby wall part of one layout question. Keep one record for the chosen edge: profile identity, drawing revision, panel interface, connections and door movement. Bring that complete detail back into the van model before preparing the finished pieces. My original reference is an edge-shape idea; the drawing records the assembly being considered. Thanks for watching. I'm Steve Smith with Camper Van Freedom. Start with the cross-section, then draw the whole cabinet edge. See you next time.