I bought VHT Gloss Black Epoxy Paint as part of my camper van equipment.
Gloss-black paint is part of my exterior and hardware finishing purchases, where the diary records several approaches to coating prepared surfaces.
Where it fits my build
I taped the boundaries and covered the areas that would not be painted with plastic sheeting. I then sanded the exposed areas with an orbital sander and 60-grit abrasive, blew away the dust with a compressor, and cleaned and degreased the surfaces.
I mixed clear bedliner with white tint and sprayed the van. After it dried, I removed the masking. The tape and sheeting stage alone took around eight hours, and the finished edges still needed some touch-up.
My van with masking around the exterior areas prepared for coating.The side of the van during the white-bedliner project.
My build notes
The most useful detail in my diary is the result, including the problems. Rust-Oleum pooled and dripped in places, and trying to repair one area with a paintbrush made it worse. I wrote that I would use a foam roller for touch-ups and preferred the more consistent finish I had obtained with RAPTOR.
Masking, preparation and application method each became a substantial part of the exterior-coating job.
Alternative products
Two alternatives to compare
The Rust-Oleum and Krylon options also provide a gloss-black spray finish. They are separate paint formulations from VHT's epoxy product.
Rust-Oleum Gloss Black Spray Paint
This Rust-Oleum gloss-black paint comes in an aerosol can. The spray format provides a black coating without a separate paint cup and compressor-fed gun.
