I bought Leviton PJ11-W Midway Cable Wall Plate as part of my camper van equipment.
This cable wall plate is one of the small finishing parts in my electrical purchases.
Where it fits my build
I brought the roof light wires and camera cables into a PVC conduit layout. That work included drilled enclosures, threaded fittings, cable glands, solder-seal splices and grouped wiring.
During the small-box stage, I drilled for a male PVC fitting and used a fitting inside as a retaining nut. I routed the camera cable through a gland into a tee and brought the light-wire groups toward the van entry.
The larger roof enclosure during my cable-entry work.A grouped roof-wire connection before the final conduit work.
My build notes
The wiring project was a sequence of individual connections and routes. The photographs show the intermediate stages, including open boxes and wrapped wire groups, before the remaining covers and conduit joints were finished.
I built the cable route a section at a time, bringing local connections into the larger conduit system.
Alternative products
Two alternatives to compare
The standard Leviton cable plate uses a smaller outline around its cable opening. The ENERLITES blank plate closes an unused opening instead of providing a cable passage.
Leviton Standard Cable Wall Plate
This white single-gang plate has a central opening for a cable. Its standard outline provides a smaller plate format than Leviton's midway version.
