This longer terminal-strip set was another connection-hardware purchase for my build. It sits alongside the compact four-position blocks and the covered stud-type bus bars in my electrical kit.
The larger roof enclosure during my cable-entry work.
The item in my kit
I bought Twelve-Position Terminal Block Set as part of my camper van equipment.
This longer terminal-strip set was another connection-hardware purchase for my build. It sits alongside the compact four-position blocks and the covered stud-type bus bars in my electrical kit.
Where it fits my build
I brought the roof light wires and camera cables into a PVC conduit layout. That work included drilled enclosures, threaded fittings, cable glands, solder-seal splices and grouped wiring.
During the small-box stage, I drilled for a male PVC fitting and used a fitting inside as a retaining nut. I routed the camera cable through a gland into a tee and brought the light-wire groups toward the van entry.
A grouped roof-wire connection before the final conduit work.
My build notes
The wiring project was a sequence of individual connections and routes. The photographs show the intermediate stages, including open boxes and wrapped wire groups, before the remaining covers and conduit joints were finished.
I built the cable route a section at a time, bringing local connections into the larger conduit system.
Alternative products
Two alternatives to compare
MILAPEAK uses shorter four-position screw blocks, while WAGO lever connectors divide the connections into separate compact bodies with a different clamping method.
MILAPEAK Four-Position Terminal Blocks
These dual-row screw-terminal blocks provide four connection positions under removable covers. The set includes matching insulated jumper strips.
