I bought this Veepeak plug among the van's shore-power components. A replaceable cord end is a separate piece of equipment from the fixed cable-entry parts visible in my roof diary.
The larger roof enclosure during my cable-entry work.
The item in my kit
I bought Veepeak TT-30P Replacement Plug as part of my camper van equipment.
I bought this Veepeak plug among the van's shore-power components. A replaceable cord end is a separate piece of equipment from the fixed cable-entry parts visible in my roof diary.
Where it fits my build
I brought the roof light wires and camera cables into a PVC conduit layout. That work included drilled enclosures, threaded fittings, cable glands, solder-seal splices and grouped wiring.
During the small-box stage, I drilled for a male PVC fitting and used a fitting inside as a retaining nut. I routed the camera cable through a gland into a tee and brought the light-wire groups toward the van entry.
A grouped roof-wire connection before the final conduit work.
My build notes
The wiring project was a sequence of individual connections and routes. The photographs show the intermediate stages, including open boxes and wrapped wire groups, before the remaining covers and conduit joints were finished.
I built the cable route a section at a time, bringing local connections into the larger conduit system.
Alternative products
Two alternatives to compare
Camco's Power Grip plug and the Nilight TT-30P plug provide two other handled replacement ends in the same connector pattern, with different housing shapes.
Camco Power Grip TT-30P Plug
This replacement RV plug uses the TT-30P three-prong pattern. A shaped grip on the housing helps handle the cord end.
