A precision-screwdriver set appears in my purchases alongside the electrical fittings and small hardware.
The featured Amazon option is iFixit Mako Driver Kit.
Where it fits my build
I brought the roof light wires and camera cables into a PVC conduit layout. That work included drilled enclosures, threaded fittings, cable glands, solder-seal splices and grouped wiring.
During the small-box stage, I drilled for a male PVC fitting and used a fitting inside as a retaining nut. I routed the camera cable through a gland into a tee and brought the light-wire groups toward the van entry.
The larger roof enclosure during my cable-entry work.A grouped roof-wire connection before the final conduit work.
My build notes
The wiring project was a sequence of individual connections and routes. The photographs show the intermediate stages, including open boxes and wrapped wire groups, before the remaining covers and conduit joints were finished.
I built the cable route a section at a time, bringing local connections into the larger conduit system.
Alternative products
Two alternatives to compare
The iFixit Mako uses interchangeable bits. The Wiha sets provide individual precision drivers, with slotted and Phillips tips in one set and Torx tips in the other.
Wiha Precision Slotted and Phillips Drivers
This seven-piece set provides individual slotted and Phillips precision screwdrivers. Rotating caps support fingertip control of the slim drivers.
