Connecting wires into a route and terminating them at hardware are separate tasks. This lug kit is part of my purchased electrical supplies for the termination side of the build kit.
The larger roof enclosure during my cable-entry work.
The item in my kit
I bought AKEOIL Cable Lug and Heat-Shrink Kit as part of my camper van equipment.
Connecting wires into a route and terminating them at hardware are separate tasks. This lug kit is part of my purchased electrical supplies for the termination side of the build kit.
Where it fits my build
I brought the roof light wires and camera cables into a PVC conduit layout. That work included drilled enclosures, threaded fittings, cable glands, solder-seal splices and grouped wiring.
During the small-box stage, I drilled for a male PVC fitting and used a fitting inside as a retaining nut. I routed the camera cable through a gland into a tee and brought the light-wire groups toward the van entry.
A grouped roof-wire connection before the final conduit work.
My build notes
The wiring project was a sequence of individual connections and routes. The photographs show the intermediate stages, including open boxes and wrapped wire groups, before the remaining covers and conduit joints were finished.
I built the cable route a section at a time, bringing local connections into the larger conduit system.
Alternative products
Two alternatives to compare
TKDMR and Haisstronica offer other lug-and-tubing assortments. Their included barrel and ring sizes define the range of cable-end combinations available.
TKDMR Cable Lug and Heat-Shrink Kit
This TKDMR kit groups cable lugs and heat-shrink pieces in an assortment. Each lug combines a wire-entry barrel with a ring for a bolted connection.
