The DAIERTEK set records a six-stud arrangement in my electrical purchases. The paired positive-and-negative bars give this entry a different package layout from an individual common bar.
The larger roof enclosure during my cable-entry work.
The item in my kit
I bought DAIERTEK Six-Stud Bus Bar Set as part of my camper van equipment.
The DAIERTEK set records a six-stud arrangement in my electrical purchases. The paired positive-and-negative bars give this entry a different package layout from an individual common bar.
Where it fits my build
I brought the roof light wires and camera cables into a PVC conduit layout. That work included drilled enclosures, threaded fittings, cable glands, solder-seal splices and grouped wiring.
During the small-box stage, I drilled for a male PVC fitting and used a fitting inside as a retaining nut. I routed the camera cable through a gland into a tee and brought the light-wire groups toward the van entry.
A grouped roof-wire connection before the final conduit work.
My build notes
The wiring project was a sequence of individual connections and routes. The photographs show the intermediate stages, including open boxes and wrapped wire groups, before the remaining covers and conduit joints were finished.
I built the cable route a section at a time, bringing local connections into the larger conduit system.
Alternative products
Two alternatives to compare
RVBOATPAT supplies another six-stud pair, while the four-post set uses fewer main connection positions on each bar.
RVBOATPAT Six-Stud Bus Bar Set
This bus bar set provides positive and negative distribution bars with six threaded studs each. Removable covers sit over the connection hardware.
This pair of covered bus bars provides four threaded connection posts on each bar. The posts have 5/16-inch stud threads for ring-terminal connections.
