Cable entry was a substantial part of my roof project: I drilled enclosures and brought the grouped wiring into the van. This Link Solar housing is another entry component in my purchased kit.
The larger roof enclosure during my cable-entry work.
The item in my kit
I bought Link Solar Double Cable-Entry Gland as part of my camper van equipment.
Cable entry was a substantial part of my roof project: I drilled enclosures and brought the grouped wiring into the van. This Link Solar housing is another entry component in my purchased kit.
Where it fits my build
I brought the roof light wires and camera cables into a PVC conduit layout. That work included drilled enclosures, threaded fittings, cable glands, solder-seal splices and grouped wiring.
During the small-box stage, I drilled for a male PVC fitting and used a fitting inside as a retaining nut. I routed the camera cable through a gland into a tee and brought the light-wire groups toward the van entry.
A grouped roof-wire connection before the final conduit work.
My build notes
The wiring project was a sequence of individual connections and routes. The photographs show the intermediate stages, including open boxes and wrapped wire groups, before the remaining covers and conduit joints were finished.
I built the cable route a section at a time, bringing local connections into the larger conduit system.
Alternative products
Two alternatives to compare
Renogy offers another two-cable housing, while the MAKERELE assortment supplies individual enclosure glands in several sizes; the physical enclosure layout differs between those approaches.
Renogy Double Cable-Entry Housing
This entry housing groups two compression glands under a shaped cover. Each gland provides a separate cable entry through the housing.
