These small screw-cap holders were part of my electrical purchases for the build. Their panel-mounted form contrasts with the covered blade-fuse blocks elsewhere in my kit.
The larger roof enclosure during my cable-entry work.
The item in my kit
I bought Uxcell Panel-Mount Cartridge Fuse Holders as part of my camper van equipment.
These small screw-cap holders were part of my electrical purchases for the build. Their panel-mounted form contrasts with the covered blade-fuse blocks elsewhere in my kit.
Where it fits my build
I brought the roof light wires and camera cables into a PVC conduit layout. That work included drilled enclosures, threaded fittings, cable glands, solder-seal splices and grouped wiring.
During the small-box stage, I drilled for a male PVC fitting and used a fitting inside as a retaining nut. I routed the camera cable through a gland into a tee and brought the light-wire groups toward the van entry.
A grouped roof-wire connection before the final conduit work.
My build notes
The wiring project was a sequence of individual connections and routes. The photographs show the intermediate stages, including open boxes and wrapped wire groups, before the remaining covers and conduit joints were finished.
I built the cable route a section at a time, bringing local connections into the larger conduit system.
Alternative products
Two alternatives to compare
Joinfworld supplies panel holders with attached leads, while the BOJACK kit uses inline holders and a selection of glass fuses; access and mounting style differ.
Joinfworld Panel-Mount Fuse Holders
These screw-cap holders mount 5-by-20-millimeter cartridge fuses through a panel. The package includes attached leads and glass fuses.
