I bought FoamPRO 9-Inch Foam Roller Cover as part of my camper van equipment.
This foam roller cover is part of my painting supplies, a recurring part of the van finishing work.
Where it fits my build
I taped the boundaries and covered the areas that would not be painted with plastic sheeting. I then sanded the exposed areas with an orbital sander and 60-grit abrasive, blew away the dust with a compressor, and cleaned and degreased the surfaces.
I mixed clear bedliner with white tint and sprayed the van. After it dried, I removed the masking. The tape and sheeting stage alone took around eight hours, and the finished edges still needed some touch-up.
My van with masking around the exterior areas prepared for coating.The side of the van during the white-bedliner project.
My build notes
The most useful detail in my diary is the result, including the problems. Rust-Oleum pooled and dripped in places, and trying to repair one area with a paintbrush made it worse. I wrote that I would use a foam roller for touch-ups and preferred the more consistent finish I had obtained with RAPTOR.
Masking, preparation and application method each became a substantial part of the exterior-coating job.
Alternative products
Two alternatives to compare
The Wooster cover is also nine inches wide but uses a knit fabric surface. The XDT mini rollers offer a smaller foam format for narrower sections.
Wooster Super Fab 9-Inch Roller Covers
These nine-inch roller covers use a knit fabric surface with a three-eighths-inch nap. The twelve-pack supplies replacement covers for repeated painting sessions.
