I bought 3M SandBlaster 80-Grit Sponge as part of my camper van equipment.
The sanding sponge is part of the hand-finishing supplies I bought for work around smaller edges and uneven surfaces.
Where it fits my build
I taped the boundaries and covered the areas that would not be painted with plastic sheeting. I then sanded the exposed areas with an orbital sander and 60-grit abrasive, blew away the dust with a compressor, and cleaned and degreased the surfaces.
I mixed clear bedliner with white tint and sprayed the van. After it dried, I removed the masking. The tape and sheeting stage alone took around eight hours, and the finished edges still needed some touch-up.
My van with masking around the exterior areas prepared for coating.The side of the van during the white-bedliner project.
My build notes
The most useful detail in my diary is the result, including the problems. Rust-Oleum pooled and dripped in places, and trying to repair one area with a paintbrush made it worse. I wrote that I would use a foam roller for touch-ups and preferred the more consistent finish I had obtained with RAPTOR.
Masking, preparation and application method each became a substantial part of the exterior-coating job.
Alternative products
Two alternatives to compare
Jamiikury supplies a pack of ready-coated eighty-grit sponges. The 3M rubber block instead holds a separate sheet of abrasive, making the abrasive replaceable independently of the block.
Jamiikury 80-Grit Sanding Sponges
These sanding sponges combine an eighty-grit abrasive with a foam block. The pack provides multiple ready-coated blocks for hand sanding.
