The wiring work involved preparing leads before arranging splices and routing them through boxes. This dedicated cutter is part of my purchased electrical hand-tool kit for that preparation stage.
The larger roof enclosure during my cable-entry work.
The item in my kit
I bought TOOLEAGUE Cable Cutter as part of my camper van equipment.
The wiring work involved preparing leads before arranging splices and routing them through boxes. This dedicated cutter is part of my purchased electrical hand-tool kit for that preparation stage.
Where it fits my build
I brought the roof light wires and camera cables into a PVC conduit layout. That work included drilled enclosures, threaded fittings, cable glands, solder-seal splices and grouped wiring.
During the small-box stage, I drilled for a male PVC fitting and used a fitting inside as a retaining nut. I routed the camera cable through a gland into a tee and brought the light-wire groups toward the van entry.
A grouped roof-wire connection before the final conduit work.
My build notes
The wiring project was a sequence of individual connections and routes. The photographs show the intermediate stages, including open boxes and wrapped wire groups, before the remaining covers and conduit joints were finished.
I built the cable route a section at a time, bringing local connections into the larger conduit system.
Alternative products
Two alternatives to compare
The Klein cutter offers another direct hand-operated cutting format. KF CPTEC uses a ratcheting mechanism that advances the cut in stages.
Klein 63050 Cable Cutter
The Klein 63050 uses curved cutting jaws with two hand grips. It is a dedicated cable-cutting tool rather than a combined stripper and crimper.
